‌How to remove the car plastic buckle

There are many ways to remove the car plastic buckle. The following are two common ways:

Use special tools:

Go to the auto repair shop to borrow special tools, which can remove the car plastic buckle more conveniently and quickly. ‌

Stick the special tool at the top of the buckle, and then gently push it upward to remove the buckle.

If you can't find the special tool, you can use a screwdriver to remove it. Insert the screwdriver into the gap of the buckle, and then gently pry it until the buckle loosens and can be removed.

Please note that using a screwdriver to remove may damage the buckle, so it is only recommended to use it when you can't find the special tool.

Steps to remove the car expansion buckle

Take the fender outer expansion buckle as an example, the specific removal method is as follows:

Prepare tools:

You need to prepare tools for removing the buckle, such as a hexagonal diamond or a cross-shaped small wrench.

Insert the tool:

Insert the cross-shaped end of the small wrench directly into the knife groove opposite the expansion buckle.

Rotating tool:

Turn the small wrench counterclockwise. When the buckle rotates to a certain degree, remove the buckle.

* Note:

During the disassembly process, be gentle to avoid excessive force that may damage the interior panel or buckle.

For buckles with threads on the car, such as expansion buckles, do not use flat-blade screwdrivers or other non-professional tools to forcibly pry them open to avoid damaging the thread structure.

If you want to install the buckle to its original place, you need to pay attention to observe from four directions, front, back, left, and right, from multiple angles to see if the buckle has been completely matched successfully.